audio
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
audio [2021/07/16 16:39] – elarrieu | audio [2021/07/16 17:36] – elarrieu | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Audio ====== | ====== Audio ====== | ||
- | [under construction...] | + | **[UNDER CONSTRUCTION...]** |
---- | ---- | ||
Powering on the system: | Powering on the system: | ||
- | - Mixer | + | - Mixer (power button is on the back right above the main Power cable) |
- | - Computer | + | - Computer |
- | - Speakers (via Siemens panel) | + | - Speakers (via Siemens panel --> turn on all **odd numbered** outlets on the second spotlight page [add image(s)]) |
---- | ---- | ||
- | Audio output: | + | Audio output |
* Audio output should be set to Dante in Audio software | * Audio output should be set to Dante in Audio software | ||
- | * * It's best to keep the system output set to " | + | * NOTE: It's best to keep the system output set to " |
+ | * Sample rate should be set to 48 kHz | ||
+ | * **IMPORTANT: | ||
+ | |||
+ | ---- | ||
+ | |||
+ | Using the mixer: | ||
+ | * If it's not already loaded, be sure that **SCENE 101 HELLOWORLD210713** is loaded [update this, add picture(s)] | ||
+ | * **To Do:** add overview of different scenes (i.e. default multichannel, | ||
+ | * 37 main output channels are connected to the speakers by default (access via Dante ch. 1-37) | ||
+ | * 4 subwoofer output channels are connected to the speakers by default (access via Dante ch. 45-48) | ||
+ | * the omni ins are channels 49-56 **(the minijack input are channels 49-50)** | ||
+ | * The master faders for the mains and subs are the two on the righthand side of the mixer. | ||
+ | * all input faders should be set to 0 dB | ||
+ | * output faders (in the output section (LS 01 - 30 + SUB 1 & 2) should be set to -20 | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | Troubleshooting: | ||
+ | **I'm not getting any sound!** | ||
+ | |||
+ | It's best to go in a linear fashion from source (computer) to destination (speakers) --> need to sort this better (maybe add a check system diagram/ | ||
+ | * Double-check that everything is powered on | ||
+ | * **You may need to wait for up to 10 minutes for all the connections to be established** (although typically at least some of the speakers play right away after power up). | ||
+ | * make sure you've selected Dante 64 as the audio output in your software [add: examples in Max, Reaper] | ||
+ | * open Max and use **Audiotester_64_ch** (in the Extras menu) --> set source: **Pink noise**, Step Out1 from **Chan. 1** to **Chan. 48**, **click the button** on the left to start the test | ||
+ | * Do you see any lights on the meters for channel 1 and 2 on the mixer? | ||
+ | * Reload the default mixer setting (**SCENE 101 HELLOWORLD210713**) | ||
+ | * add separate instructions for minijack... | ||
audio.txt · Last modified: 2021/07/16 17:46 by elarrieu