Differences

This shows you the differences between two versions of the page.

--- motive_calibrating [2019/08/21 08:40] – 10.130.132.100
+++ motive_calibrating [2019/08/21 21:24] (current) – nkottman
@@ Line 123: / Line 123: @@
-=== Masking ===
+=== Masking / LED ===
-Once all the reflections are removed, Clear the previously set masks by pressing ''Clear Mask'' in the Calibration pane. Then set the masks again by pressing ''Mask visible''. it is important that nobody is inside the space at this moment.
+Clear the previously set masks by pressing ''Clear Mask'' in the Calibration pane. Disable all infrared LED light of the cameras by pressing ''LED in the Device pane''. Active wands do not need LED lights from the camera.
@@ Line 155: / Line 154: @@
 === Ground Plane ===
+**Enable the LED lights** of the cameras by pressing ''LED in the Device pane''.
 Make sure that the **Tracking Mode is set to back to Passive**. Otherwise, press ''Passive, Active'' Symbol in 3D View.
@@ Line 176: / Line 177: @@
 The calibration is now finished.